Gigabyte GA-8I915G-MF User Manual download pdf (Page 21)

Hardware Installation- 21 -

English

6) IDE (IDE Connector)

An IDE device connects to the computer via an IDE connector. One IDE connector can connect to one

IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical drive). If

you wish to connect two IDE devices, please set the jumper on one IDE device as Master and the other

as Slave (for information on settings, please refer to the instructions located on the IDE device).

Pin No. Definition

1 GND

2 TXP

3 TXN

4 GND

5 RXN

6 RXP

7 GND

3940

7) S_ATA0/S_ATA1/S_ATA2/S_ATA3 (Serial ATA Connector, Controlled by ICH6)

Serial ATA can provide 150MB/s transfer rate. Please refer to the BIOS setting for the Serial ATA

and install the proper driver in order to work properly.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 79 80

GA-8I915G-MF 1
GA-8I915GM 1
Motherboard 2
Jun. 11, 2004 2
Copyright 3
Product Manual Classification 3
Table of Content 4
Block Diagram 7
Preparing Your Computer 9
Installation Notices 9
Instances of Non-Warranty 9
1-2 Feature Summary 10
1-3-1 Installation of the CPU 12
Male Push Pin 13
Female Push Pin 13
The top of Female Push Pin 13
1-4 Installation of Memory 14
1-5 Install expansion cards 16
1-7 Connectors Introduction 18
5) FDD (Floppy Connector) 20
6) IDE (IDE Connector) 21
9) PWR_LED 23
11) CD_IN (CD IN) 24
16) CLR_CMOS (Clear CMOS) 26
17) BAT(Battery) 27
Chapter 2 BIOS Setup 29
BIOS Setup- 31 31
2-1 Standard CMOS Features 32
2-2 Advanced BIOS Features 34
(Note ) 35
2-3 Integrated Peripherals 36
2-4 Power Management Setup 39
Power On By Keyboard 40
KB Power ON Password 40
AC Back Function 40
2-5 PnP/PCI Configurations 41
2-6 PC Health Status 42
CPU Clock Ratio 43
Memory Frequency For 43
Memory Frequency (Mhz) 43
CPU Smart FAN Mode 43
2-8 Load Fail-Safe Defaults 44
2-9 Load Optimized Defaults 44
2-11 Save & Exit Setup 46
2-12 Exit Without Saving 46
Chapter 3 Install Drivers 47
3-2 Software Applications 48
3-3 Driver CD Information 48
3-4 Hardware Information 49
3-5 Contact Us 49
Chapter 4 Appendix 51
4-1-1 EasyTune 5 Introduction 52
Boot from CD/DVD: 53
<F9> Xpress Recovery2 53
System requirements: 53
The BIOS file is Fa3 55
Using the Q-Flash 57
utility: 57
8KNXPU.Fba, is listed 57
Part Two: 59
Updating BIOS with Q-Flash 59
Do not trun off power or 61
Method 2 : @BIOS 62
Utility 62
1. Methods and steps: 62
2. Note: 63
4 Channel Audio Setup 65
6 Channel Audio Setup 66
8 Channel Audio Setup 67
4-2 Troubleshooting 68
Appendix- 69 69
Appendix- 71 71
Appendix- 73 73
Appendix- 75 75
Appendix- 77 77
Contact Us 79

Comments to this Manuals

No comments

Gigabyte GA-8I915G-MF User Manual Page 21

Comments to this Manuals

Related products and manuals for Hardware Gigabyte GA-8I915G-MF