Gigabyte GA-MA790FXT-UD5P User Manual Page 53
- Page / 112
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
- 53 - BIOS Setup
Start detecting at Port.....
Link Detected --> 100Mbps
Cable Length= 30m
When LAN Cable Is Functioning Normally...
If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub,
the following message will appear:
Link Detected Displays transmission speed
Cable Length Displays the approximate length of the attached LAN cable.
Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate
at a normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is
activated.
When a Cable Problem Occurs...
If a cable problem occurs on a specified pair of wires, the Status field will show Short and
thenlength shown will be the approximate distance to the fault or short.
Example: Part1-2 Status = Short / Length = 2m
Explanation: A fault or short might occur at about 2m on Part 1-2.
Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Status fields will
show Open, and the length shown is the approximate length of the attached LAN cable.
Onboard 1394 Function
Enables or disables the onboard IEEE 1394 function. (Default: Enabled)
OnChip USB Controller
Enables or disables the integrated USB 1.1 controller. (Default: Enabled)
USB EHCI Controller
Enables or disables the integrated USB 2.0 controller. (Default: Enabled)
USB Keyboard Support
Allows USB keyboard to be used in MS-DOS. (Default: Disabled)
USB Mouse Support
Allows USB mouse to be used in MS-DOS. (Default: Disabled)
Legacy USB storage detect
Determines whether to detect USB storage devices, including USB flash drives and USB hard
drives during the POST. (Default: Enabled)
Onboard Serial Port 1
Enables or disables the first serial port and specifies its base I/O address and corresponding
interrupt. Options are: Auto, 2F8/IRQ3, 3F8/IRQ4(default), 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and
corresponding interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
- GA-MA790FXT-UD5P 1
- Motherboard 2
- Jan. 22, 2009 2
- Copyright 3
- Disclaimer 3
- Documentation Classifications 3
- Table of Contents 4
- Box Contents 6
- Optional Items 6
- Block Diagram 8
- 1-1 Installation Precautions 9
- 1-2 Product Specifications 10
- (Note 4) 11
- (Note 5) 12
- 1-3-1 Installing the CPU 13
- CPU Socket Locking 14
- 1-4 Installing the Memory 16
- 1-4-2 Installing a Memory 17
- PCI Express x1 Slot 18
- PCI Slot 18
- PCI Express x16 Slot 18
- CrossFireX.) 19
- SATA Bracket 20
- 1-8 Back Panel Connectors 21
- 1-9 Onboard Switches 23
- 1-10 Internal Connectors 24
- 8) IDE (IDE Connector) 27
- 12) BATTERY 30
- System Status LED 31
- S1 Blinking 31
- S3/S4/S5 Off 31
- Hardware Installation- 35 35
- Open: Normal 36
- Short: Clear CMOS Values 36
- Chapter 2 BIOS Setup 37
- 2-1 Startup Screen 38
- 2-2 The Main Menu 39
- CPU Clock Ratio 41
- CPU NorthBridge Freq 41
- CPU Host Clock Control 41
- CPU Frequency (Mhz) 41
- SB/HT Voltage Control 44
- NB/PCIe/PLL Voltage Control 44
- CPU NB VID Control 44
- CPU Voltage Control 44
- Normal CPU Vcore 44
- 2-4 Standard CMOS Features 45
- Floppy 3 Mode Support 46
- 2-5 Advanced BIOS Features 47
- HDD S.M.A.R.T. Capability 48
- Away Mode 48
- Full Screen LOGO Show 48
- Init Display First 48
- 2-6 Integrated Peripherals 49
- Smart Backup 50
- Smart Backup Config 51
- Apply RAID Config 51
- Disk/RAID Status 51
- Onboard Audio Function 52
- Onboard LAN device 52
- Start detecting at Port 53
- Link Detected --> 100Mbps 53
- Cable Length= 30m 53
- Parallel Port Mode 54
- ECP Mode Use DMA 54
- 2-7 Power Management Setup 55
- 2-8 PC Health Status 57
- 2-9 Load Fail-Safe Defaults 59
- 2-10 Load Optimized Defaults 59
- 2-12 Save & Exit Setup 61
- 2-13 Exit Without Saving 61
- 3-2 Application Software 64
- 3-3 Technical Manuals 64
- 3-4 Contact 65
- 3-5 System 65
- 3-6 Download Center 66
- Chapter 4 Unique Features 67
- B. Accessing Xpress Recovery2 68
- E. Removing the Backup 69
- F. Exiting Xpress Recovery2 69
- A. Before You Begin: 70
- B. Updating the BIOS 71
- B. Using @BIOS: 73
- C. After Updating the BIOS: 73
- 4-3 EasyTune 6 74
- 4-4 Easy Energy Saver 75
- B. Total Mode 76
- C. Stealth Mode 76
- 4-5 Q-Share 77
- 4-6 Time Repair 78
- 4-7 Teaming 79
- Chapter 5 Appendix 81
- (Note 2) 89
- (Note 1) 89
- A. Installing Windows XP 90
- B. Installing Windows Vista 91
- 5-1-5 Smart Backup Utility 94
- A. Configuring Speakers: 95
- B. Configuring Sound Effect: 96
- B. Configuring S/PDIF in: 97
- C. Configuring S/PDIF Out: 98
- * Enabling Stereo Mix 101
- A. Recording Sound: 102
- 5-3 Troubleshooting 103
- Appendix- 105 105
- 5-4 Regulatory Statements 106
- Appendix- 109 109
- Contact Us 111
Related products and manuals for Motherboard Gigabyte GA-MA790FXT-UD5P
Motherboard Gigabyte GA-MA790XT-UD4P User Manual
(112 pages)
(112 pages)
Motherboard Gigabyte GA-MA790GP-UD3H User Manual
(104 pages)
(104 pages)
Motherboard Gigabyte GA-MA78LMT-S2H User Manual
(100 pages)
(100 pages)
© 2020, manymanuals.com. All rights reserved. | 0.646 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals