Gigabyte GA-P55A-UD5 User Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 128
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
- 19 - Hardware Installation
1-6 Setup of ATI CrossFireX
/NVIDIA SLI Conguration
A. System Requirements
- Windows Vista or Windows XP operating system
- A CrossFireX/SLI-supported motherboard with two PCI Express x16 slots and correct driver
- Two CrossFireX/SLI-ready graphics cards of identical brand and chip and correct driver
- Two CrossFire
(Note )
/SLI bridge connectors
- A power supply with sufcient power is recommended (Refer to the manual of your graphics cards for
the power requirement)
B. Connecting the Graphics Cards
Step 1:
Observe the steps in "1-5 Installing an Expansion Card" and install two CrossFireX/SLI graphics cards on the
PCI Express x16 slots. For optimum graphics performance, be sure to install the cards on the PCIEX16_1
and PCIEX8_1 slots.
Step 2:
Insert the CrossFire
(Note)
/SLI bridge connectors in the CrossFireX/SLI gold edge connectors on top of the two
cards.
Step 3:
Plug the display cable into the graphics card on the PCIEX16_1 slot.
C. Conguring the Graphics Card Driver
C-1. To Enable CrossFireX Function
After installing the graphics card driver in the operating system, go to
the ATI Catalyst Control Center. Browse to the CrossFireX menu
and ensure the Enable CrossFireX
check box is selected.
(Note) The bridge connectors may be needed or not depending on your graphics cards.
Procedure and driver screen for enabling CrossFireX/SLI technology may differ by graphics cards.
Refer to the manual that came with your graphics cards for more information about enabling Cross-
FireX/SLI technology.
C-2. To Enable SLI Function
After installing the graphics card driver in the operating system, go
to the
NVIDIA Control Panel
. Browse to the
Set SLI Conguration
screen and ensure the Enable SLI technology check box is se-
lected.
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 127 128

Comments to this Manuals

No comments