Gigabyte P41-ES3G User Manual Page 51
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
- 51 - BIOS Setup
Link Detected Displays transmission speed
Cable Length Displays the approximate length of the attached LAN cable.
Start detecting at Port.....
Link Detected --> 100Mbps
Cable Length= 30m
Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate
at a normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is
activated.
When a Cable Problem Occurs...
If a cable problem occurs on a specified pair of wires, the Status field will show Short and then
length shown will be the approximate distance to the fault or short.
Example: Part1-2 Status = Short / Length = 2m
Explanation: A fault or short might occur at about 2m on Part 1-2.
Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Status fields will
show Open, and the length shown is the approximate length of the attached LAN cable.
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short.
Refer to the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show
Open and the Length fields show 0m, as shown in the figure above.
When LAN Cable Is Functioning Normally...
If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub,
the following message will appear:
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard IDE Controller (JMicron 368 Chip)
Enables or disables the IDE controller integrated in the JMicron 368 chip. (Default: Enabled)
Onboard Serial Port 1
Enables or disables the first serial port and specifies its base I/O address and corresponding
interrupt. Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and
corresponding interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel
Port)(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
- GA-EP45-DS3LR/ 1
- GA-EP45-DS3L 1
- Motherboard 2
- May 23, 2008 2
- Copyright 3
- Disclaimer 3
- Documentation Classifications 3
- Table of Contents 4
- Box Contents 6
- Optional Items 6
- GA-EP45-DS3LR/DS3L 7
- Block Diagram 8
- 1-1 Installation Precautions 9
- (Note 2) 11
- (Note 3) 12
- 1-3-1 Installing the CPU 13
- CPU Socket Lever 14
- 1-4 Installing the Memory 16
- 1-4-2 Installing a Memory 17
- PCI Express x1 Slot 18
- PCI Slot 18
- PCI Express x16 Slot 18
- 1-6 Back Panel Connectors 19
- 1-7 Internal Connectors 21
- 7) IDE (IDE Connector) 24
- System Status LED 27
- S1 Blinking 27
- S3/S4/S5 Off 27
- Pin No. Definition 31
- 1 Signal 31
- Open: Normal 31
- Short: Clear CMOS Values 31
- 21) PHASE LED 32
- 20) BATTERY 32
- Chapter 2 BIOS Setup 33
- 2-1 Startup Screen 34
- 2-2 The Main Menu 35
- - 37 - BIOS Setup 37
- Robust Graphics Booster 38
- CPU Clock Ratio 38
- Fine CPU Clock Ratio 38
- CPU Frequency 38
- CPU Host Clock Control 38
- CPU Host Frequency (Mhz) 39
- PCI Express Frequency (Mhz) 39
- Advanced Clock Control 39
- Advanced Timing Control 41
- CAS Latency Time 41
- 2-4 Standard CMOS Features 44
- Floppy 3 Mode Support 45
- 2-5 Advanced BIOS Features 46
- Delay For HDD (Secs) 48
- Full Screen LOGO Show 48
- Init Display First 48
- 2-6 Integrated Peripherals 49
- Onboard LAN Boot ROM 51
- Onboard Serial Port 1 51
- Onboard Parallel Port 51
- Parallel Port Mode 51
- 2-7 Power Management Setup 52
- 2-8 PnP/PCI Configurations 54
- 2-10 Load Fail-Safe Defaults 56
- 2-11 Load Optimized Defaults 56
- 2-13 Save & Exit Setup 58
- 2-14 Exit Without Saving 58
- 3-2 Application Software 60
- 3-3 Technical Manuals 60
- 3-4 Contact 61
- 3-5 System 61
- 3-6 Download Center 62
- Chapter 4 Unique Features 63
- B. Accessing Xpress Recovery2 66
- E. Removing the Backup 67
- F. Exiting Xpress Recovery2 67
- 4-2 BIOS Update Utilities 68
- B. Updating the BIOS 69
- A. Before You Begin: 71
- C. After Updating the BIOS: 71
- B. Using @BIOS: 71
- 4-3 EasyTune 6 72
- (Note 1) 73
- (Note 2) 73
- (Note 4) 74
- (Note 5) 74
- 4-5 Q-Share 75
- 4-6 Time Repair 76
- Chapter 5 Appendix 77
- A. Installing Windows XP 85
- Appendix- 87 87
- Figure 5 87
- B. Installing Windows Vista 88
- A. Configuring Speakers: 90
- B. Configuring Sound Effect: 91
- S/PDIF In 92
- S/PDIF Out: 93
- C. Configuring S/PDIF out: 93
- Recording Control 95
- Recording the Sound: 96
- Playing the Sound: 96
- 5-3 Troubleshooting 97
- Appendix- 99 99
- 5-4 Regulatory Statements 100
- Contact Us 103
Related products and manuals for Motherboards Gigabyte P41-ES3G
Motherboards Gigabyte GA-790XTA-UD4 User Manual
(120 pages)
(120 pages)
Motherboards Gigabyte GA-870A-UD3 User Manual
(116 pages)
(116 pages)
Motherboards Gigabyte GA-890GPA-UD3H User Manual
(120 pages)
(120 pages)
Motherboards Gigabyte GA-P55-UD3L User Manual
(128 pages)
(128 pages)
Motherboards Gigabyte GA-P55-US3L User Manual
(120 pages)
(120 pages)
Motherboards Gigabyte GA-P55M-UD4 User Manual
(120 pages)
(120 pages)
Motherboards Gigabyte GA-P55A-UD4P User Manual
(128 pages)
(128 pages)
Motherboards Gigabyte GA-X58A-UD3R User Manual
(136 pages)
(136 pages)
Motherboards Gigabyte GA-770TA-U3 User Manual
(120 pages)
(120 pages)
Motherboards Gigabyte GA-5AX User Manual
(97 pages)
(97 pages)
Motherboards Gigabyte GA-P67A-UD3 User Manual
(104 pages)
(104 pages)
© 2020, manymanuals.com. All rights reserved. | 0.886 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals