Gigabyte Network Device GA-7N400 User Manual download pdf (Page 7)

Windows NT Operating System

Insert the floppy in the floppy disk drive and click Have Disk.

The next window is asking for the location of the driver. Most floppy disk drives are configured as [A:].

To verify, click on Browse.

The next window verifies that the appropriate file is located on [A:]. Select the file Oemsetup.inf and

click Open.

[A:] should appear in the window. Click OK

The next window allows you to select which driver to install. Only one driver should appear in this

window. Select SiI 3112 Raid Controller and click on OK.

It is always good to Restart the computer after an installation. Click Yes.

To install the SATARaid GUI, use Windows InstallShield by performing the following:

1. After computer restarts, insert cd in disk drive.

2. Double-click on Install SATARaid.exe.

3. Follow on-screen instructions to complete installation. Note: Do NOT install in the Start Up folder.

Choose the Default folder (normally Accessories or Administrative Tools or something similar).

Windows 98/Me Operating System

Follow the instructions in each window, using the driver installation files (siI3112r.sys) on the

floppy disk as necessary.

To install the SATARaid GUI, use Windows InstallShield by performing the following:

1. After computer restarts, insert cd in disk drive.

2. Double-click on Install SATARaid.exe.

3. Follow on-screen instructions to complete installation. Note: Do NOT install in the Start Up folder.

Choose the Default folder (normally Accessories or Administrative Tools or something similar).

SATA RAID Function

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

No comments

Gigabyte Network Device GA-7N400 User Manual Page 7