Gigabyte GA-A55M-DS2 User Manual download pdf (Page 13)

- 13 -

1-7 Back Panel Connectors

PS/2 Keyboard and PS/2 Mouse Port

Use the upper port (green) to connect a PS/2 mouse and the lower port (purple) to connect a PS/2 keyboard.

D-Sub Port

(Note1)

The D-Sub port supports a 15-pin D-Sub connector. Connect a monitor that supports D-Sub connection

to this port.

DVI-D Port

(Note1)(Note2)

The DVI-D port conforms to the DVI-D specication and supports a maximum resolution of 1920x1200

(the actual resolutions supported depend on the monitor being used). Connect a monitor that supports

DVI-D connection to this port.

USB 2.0/1.1 Port

The USB port supports the USB 2.0/1.1 specication. Use this port for USB devices such as a USB key-

board/mouse, USB printer, USB ash drive and etc.

RJ-45LANPort

The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following

describes the states of the LAN port LEDs.

(Note 1) All integrated graphics ports do not support Hot plug. If you want to change to another graphics port

when the computer is on, be sure to turn off the computer rst.

(Note 2) The DVI-D port does not support D-Sub connection by adapter.

Activity LED:

State Description

Blinking Data transmission or receiving is occurring

Off No data transmission or receiving is occurring

Connection/Speed LED:

State Description

Orange 1 Gbps data rate

Green 100 Mbps data rate

Off 10 Mbps data rate

Activity LED

Connection/

Speed LED

LAN Port

LineInJack(Blue)

The default line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.

LineOutJack(Green)

The default line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be

used to connect front speakers in a 4/5.1/7.1-channel audio conguration.

MicInJack(Pink)

The default Mic in jack. Microphones must be connected to this jack.

To congure 7.1-channel audio, you have to use an HD front panel audio module and enable the

multi-channel audio feature through the audio driver.

When removing the cable connected to a back panel connector, rst remove the cable from your •

device and then remove it from the motherboard.

When removing the cable, pull it straight out from the connector. Do not rock it side to side to •

prevent an electrical short inside the cable connector.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Comments to this Manuals

No comments

Gigabyte GA-A55M-DS2 User Manual Page 13

Comments to this Manuals

Related products and manuals for Motherboards Gigabyte GA-A55M-DS2