Gigabyte GA-D510UD Datasheet download pdf (Page 20)

Hardware Installation - 20 -

10) F_PANEL (Front Panel Header)

Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status

indicator on the chassis to this header according to the pin assignments below. Note the positive and

negative pins before connecting the cables.

• PW (Power Switch):

 Connectstothepowerswitchonthechassisfrontpanel.Youmaycongurethewaytoturnoffyour

system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management Setup," for

more information).

• HD (Hard Drive Activity LED)

Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive

is reading or writing data.

• RES (Reset Switch):

Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer

if the computer freezes and fails to perform a normal restart.

• NC:

No connection.

• MSG/PWR (Message/Power/Sleep LED):

Connects to the power status indicator on the chassis front panel. The LED

is on when the system is operating. The LED keeps blinking when the sys-

tem is in S1 sleep state. The LED is off when the system is in S3/S4 sleep

state or powered off (S5).

System Status LED

S0 On

S1 Blinking

S3/S4/S5 Off

The front panel design may differ by chassis. A front panel module mainly consists of power

switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your

chassis front panel module to this header, make sure the wire assignments and the pin assign-

ments are matched correctly.

MSG-

PW-

MSG+

PW+

Message/Power/

Sleep LED

Power

Switch

HD-

RES+

HD+

RES-

Hard Drive

Activity LED

Reset

Switch

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

Comments to this Manuals

No comments

Gigabyte GA-D510UD Datasheet Page 20

Comments to this Manuals

Related products and manuals for Motherboards Gigabyte GA-D510UD